Is it going to be okay to use, or does it get old just sitting there? If I use a braided steel line, what do you do with the extra when I push the fridge back in? (not knowing that might be why I never used it)įor the moment I have the water turned off. What is the proper procedure? Should I give it another quarter turn, or will that risk damaging it?Ģ) I bought a braided steel line 10 years ago but never used it. I have always used the old fitting and cranked it as tight as I could using 2 wrenches. I can buy a 5/16 to 1/4 compression fitting. It seemed fine, but in 30 minutes I saw some water, so it was leaking.ġ) Do the directions make sense? I have to disconnect my 1/4" copper line to my humidifier at least once a year to replace the inline filter. But the refrigerator line is hard plastic 5/16 and the water supply line is 1/4 flexible with nipples at both ends. 15 Braided Stainless Steel Fridge Water Line with 1/4' Compression Fittings Pex Tubing Core and Water Splitter. I couldn't really finger tighten it at all, but tried to follow the directions and not over tighten. CGELE Refrigerator Water Line Kit Ice Maker Water Line Kit with 1/4' OD 39.4ft Water Line Reverse Osmosis Quick Connect Fittings Push To Connect Water Tube Fittings for Fridge Ice. I cut off the old fitting and reinstalled it. ![]() I am thinking of securing the end of that 25’ line to the wall behind new fridge location and attaching a short braided line to hook up to the fridge. I bought a 25’ braided line but it is a bit short for comfort. The existing line is a compression fitted copper. (I put a water detector back there, and I guess it paid off) The instructions say to use new fitting (he reused the old one) and to tighten it by hand and then one additional half turn. I am moving fridge further from the current water source (sink). Loosen the compression nut fitting with a wrench, if your Kenmore uses the old compression nut. A week later there is a small amount of water behind the fridge so obviously it leaked. French Door Bottom-Freezer Refrigerator Kenmore Elite 73157 28. I told him you don't use teflon on compression fittings, so he did it without and it seemed fine. A refrigerator needs a water supply line when it has an ice maker or it dispenses filtered water. ![]() The installer wrapped teflon around the threads on the compression fitting, but it leaked. Connect the braided line to the Bosch hose fitting. ![]() Buy a 1/4 comp x 1/4 comp brass ball valve. The ice maker is hooked up with 1/4" copper. Most refrigerator supply lines are 1/4 inch in diameter, and they terminate with a male or female compression fitting. Buy a water 1/4 compression x 1/4 compression SS braided hose.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |